![]() ![]() **Facility power is not present, power cord is not attached, no power supplies are installed, power supply failure has occurred, or the power button cable is disconnected. For more information, see "Power fault LEDs." ![]() *When all four LEDs described in this table flash simultaneously, a power fault has occurred. 8 Hz/cycle per sec = iLO manual reboot sequence in progress.4 Hz/cycle per sec = iLO manual reboot sequence initiated.1 Hz/cycle per sec = Remote management or firmware upgrade in progress.Power On/Standby button and system power LED*įlashing green (1 Hz/cycle per sec) = Performing power on sequenceįlashing green (1 Hz/cycle per sec) = iLO is rebooting.įlashing red (1 Hz/cycle per sec) = System critical†įlashing green (1 Hz/cycle per sec) = Network active Verify operating system support-For information about operating systems supported by ProLiant servers, see the operating system support matrices.įor more pre-installation information, see the HPE ProLiant D元60 Gen9 Server User Guide on the Hewlett Packard Enterprise website.Unpack the server shipping carton, and locate the materials and documentation necessary for installing the server.Select an installation site that meets the detailed installation site requirements described in the server user guide.For safety, environmental, and regulatory information, see Safety and Compliance Information for Server, Storage, Power, Networking, and Rack Products.If you see any damage to the charging port, power connector, or power cord, contact us.Setup Overview HPE ProLiant D元60 Gen9 Server Make sure that the connections are secure and that nothing is plugged in to the USB charging port on the power supply. If needed, select the option to update the devices.Ĭheck for things that might prevent your Surface device or Windows from starting-or the battery from charging. In the Surface app, expand Help & support to check if the update status is "You're up to date" or something else. You can quickly check the health of your Surface drivers and firmware using the Surface app. If you see the logo screen appear after a few seconds, continue to hold for the full 20 seconds until you see the logo screen again. See Force a shut down and restart your Surface for more info. Then press and hold the power button for 20 seconds. Select Start > Power > Shut down and wait a moment for your Surface to shut down. For more info, see What to do if your Surface power supply or charger doesn't work. If the LED indicator isn’t lit, you may have a problem with your power supply. The LED light should be on when your power connector is plugged into your Surface. If you see any damage to the charging port, power connector, or power cord, contact us. Plugged in, charging (won't run on battery)Ĭheck for things that might prevent your Surface device or Windows from starting-or the battery from charging. For example, you might experience one of the following issues: After your Surface turns on, you may have a problem with your battery or with Windows recognizing your battery. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |